RC SERVO WIRING DIAGRAM
Servo Wiring Information - .: fatlion
In Futaba, Hitec, and JR Radio servos, the servo and battery connections have the same polarity (+/-) and signal wiring, although the connectors are slightly different. One thing to remember: You can't reverse the direction of a servo (reversed servo) by just swapping (+) and (-) wires.
Servos Wiring Diagrams - Incedo
This means that if you have a Airtronics servo with one of the "Z" connectors, you won't have to switch (+) and (-) wires to use that servo with Futaba, Hitec, or JR Radio receivers. If you want to switch the wires around, almost all the connectors have little tabs or pins that you can push with a small pin to remove the wires and push them back into the connector in the right place.
Convert 5 wire servo to 3 wire?? - RC Groups
I think there are more and better ways to learn about servo electronics and electronics in general than trying to convert old 5 wire servos to 3 wire servos. Per the post above where someone did it, you need, at a minimum, a servo amplifier board to put in the 5 wire servo to take the place of the servo amp that was in the original 5 wire RX.
wiring two micro switches start / stop for a motor - RC Groups
You still need the servo (motor) logic (forward/reverse) command to the DPDT relay coil (red box), but so far as the limit switches: Alternately, replace the relay with a DPDT toggle switch and use a $5 servo to move the switch.
Pololu - Power HD Mini Servo HD-1160A
The HD-1160A is an inexpensive, general-purpose miniature analog servo from Power HD. Servo horns and associated hardware are included specs at 6 V: 0 sec/60°, 37 oz-in (2.7 kg-cm), 17 g.
Wiring Model Boats
PDF fileWiring Model Boats This article is intended to explain the basics of wiring a radio controlled model boats. The first usually an issue, so the cheapest standard size servo will usually fill the requirement. If the servo is acting as a sail winch, a high power type may be required.