FOR A 1970 CHEVY VOLTAGE REGULATOR WIRING DIAGRAM
externally regulated alternator to internally regulated
car is a 72 monte carlo easy way to convert a GM externally regulated charging system over to an internally regualted without cutting any wires.
Trouble-Shooting and Changing a Voltage Regulator On a
“If the wiring is all original, check two things. First, unplug the voltage regulator and see if the engine shuts off with the key as normal. If that works, replace the regulator,” Memmolo said. “Do a check of all ground connections and a voltage drop test across the battery cables. The voltage drop should not exceed 0.4 volts,” he advised.
how to rewire alternator wiring harness for internally
SAVE THE WIRE GOING TO THE VOLTAGE REGULATOR WITH THE FUSED LINK (DONT CUT IT OUT) YOU CAN USE IT IF YOU ARE GOING TO RUN A FACTORY AMP GAUGE or AMP METER or any other accessory that may need to be fused such as an ignition box i apologize, this was one of my first technical videos.. its annoying and boring but it does show the
How can I bypass the voltage regulator on a 1970 Chevrolet
How can I bypass the voltage regulator on a 1970 Chevrolet If I bypass the voltage regulator I will run one wire to the side of the alternator which one do I my 1970 chevy truck has no power to the fuse box,everything is completely dead,the alternator voltage regulator went out and heated up some of the wires and blown some fuses
THE UNIQUE PART OF THE CHEVY SYSTEM - MadElectrical
The alternator and the voltage regulator was the same as with other GM cars, but wiring layout makes the Chevy system system diagramed above is typical of the original Chevy wire harness design used in 1969,1970, and 1971. Truly the Chevy wiring system was unique.
voltage regulator wiring - Chevy Message Forum
Help - can someone tell me how to wire a 1962 impala voltage regulator? I am putting the car back together after restoring and cannot figure out how to rewire the voltage regulator. The car has a/c and has five posts for wires on the regulator, three on one side and two on the other plus a ground wire on the bottom.