DISCONNECT WIRE HARNESS JEEP WRANGLER
Wiring Harness shorted on Elec Sway Bar disconnect | Jeep
Turned the Jeep off and light went out. I pushed it again, and nothing but flashing light. I tried rocking the Jeep, and tapping on disconnect as suggested by others with no luck. I finally took the plug off and found that one of the lugs in the connector was corroded to the point it is floating around in the harness connector.
Jeep Wiring Harnesses | Quadratec
Crown Automotive Wheel Speed Sensor and Fuel Injector Wire Harness for 97-18 Jeep Vehicles $19 Trigger 6 Shooter System with Overhead Switch Mount, Underhood Relay Mount, Connector Kits for 07-18 Jeep Wrangler JK
Jeep Electronic Sway Bar Disconnect OEM Wiring Harness
Whether you're looking to maintain, optimize, or upgrade, we offer competitive pricing on Jeep Electronic Sway Bar Disconnect OEM Wiring Harness - 68002996AA for your Truck or Jeep at 4 Wheel Parts. With our selection of quality brands and expert advice, we help boost your vehicle's performance and make a statement on or off the road.
Jeep Wrangler Wiring Harnesses: Amazon
This harness was a simple plug in for my 2015 Wrangler. It took about an hour to remove the tail lights and disconnect the plugs and insert the plugs on the harness and re-connect, then thread the wire along the right side frame . I used zip ties to keep the wires secured to the frame and brought out the connector below the front bumper.
Mopar OEM Rubicon Edition Locker/Swaybar Disconnect Wiring
For use with MOPAR® Performance Axle Assemblies. Upgrade your X or Sahara model Wrangler JK with this OEM Rubicon Edition wiring harness. It is a complete engine bay, rear frame harness. It give you the ability to hook up the front and rear OEM Axle Lockers and Swaybar Disconnect feature. You will need one the OE Rubicon Switch Pod for a complete factory look.
Airbag Weight Sensor Under Seat Plug Disconnect? | Jeep
Got the wiring harness disconnected using a small screwdriver so no issues there, but I'm still curious as to what the wiring harness is for under the drivers seat? Might try to find a wiring schematic for the 08 Wrangler and see if I can figure it out.
Fog Light wiring connector? | 2018+ Jeep Wrangler Forums
The factory wiring harness section that fits on the bumper is something like $45 (I'll respond back tomorrow with the exact price) but I decided that rather than cut a wiring connector already on the Jeep, I would use the original plug rather than just splice in the wiring from the LED provided harness.
fog light harness removal????? | 2018+ Jeep Wrangler
You have to unscrew all of the 15-20 little bolts/screws around the top and bottom of the bumper. Basically, you completely disassemble the bumper to get to the harness. You have to lift off the steel plating and remove the tow hooks too. When you see the harness, you then pull out about 10 little plugs that hold it in place, it's a real PITA.