AUXILIARY FUSE RELAY BOX
Auxiliary fuse box. - Team ROXOR Forum - Unofficial
The relay feeds power to an added 6 circuit fuse box. I installed a fuse box with ground terminals. First device installed was my heater. Fuse box is fed from the battery through a circuit breaker and relay. I can now add gauges etc without having to get into the Roxor fuse box.
Painless CirKit Boss Auxiliary Fuse Blocks | JEGS
The safe way to add electrical accessories is with the Painless CirKit Boss, the first circuit isolator containing both constant and ignition hot circuits. No more tapping into an existing wire or a spare circuit at the fuse block. Using an add-on, relay-activated fuse block is the safe way.
Auxiliary Fuse Panels/Relay Boxes | Rocky Mountain Overland
Yea, just a simple fuse box should work, no need to get fancy. Most of your loads do not need to be fused as it's low power draw. Whatever switches you get just check the rating on them and make sure you don't go over. There's a good chance you won't need a relay for the rock lights but you would need to figure out the power consumption first.
Auxiliary fuse box installation on the ST1100
An auxiliary fuse box is a useful addition if you're going to be installing any electrical additions to your bike. The ST1100 fuse box is located under the left side cover next to the battery. Honda has provided one 5A accessory power supply, which, let's face it, is a bit limiting.
Auxiliary fuse box - 4x4 Community Forum
Hi All, I didn't have a factory fitted reverse camera on my 2018 Hilux, so had the boys at Toyota install me one after I bought it. They added an auxiliary fuse box. The common rail on the fuse box is wired straight to the battery. I want to change this. I want to install a relay or solenoid to only power that rail when the engine is running or when the ignition is ON.
Tech - How to install an auxiliary fuse box for less than
$10 later I had my aux fuse box, complete w/ pigtails, relays, and fuses. So I dismantled the entire fuse box using a terminal pick(i.e. removed all of the guts from the fuse box leaving it a plastic shell). From there, using shrink-tubed butt connectors I rewired the entire fuse box to the existing harnesses in the truck.